First Alert FA145C CALLING FOR SERVICE, NO AC, – 28 –, 5. AC LOSS, (Continued), Busy-Standby, OPEN CIRCUIT, Long Rng Trbl, Service Request, Total Power Failure

TROUBLE CONDITIONS (Continued)

Other Trouble Displays	5. AC LOSS
(Continued)	(or NO AC)

The system is operating on battery power only due to a power failure. If only some lights are out on the premises, check circuit breakers and fuses and reset or replace as necessary. CALL FOR SERVICE if AC power cannot be restored to the system.

6.Busy-StandbyIf this remains displayed for more than 1 minute, system is

(or dI ) disabled. CALL FOR SERVICE IMMEDIATELY .

7.OPEN CIRCUIT The keypad is not receiving signals from the control. (or OC )

8.Long Rng Trbl If programmed, back-up Long Range Radio communication has

(or bF) failed. CALL FOR SERVICE.

9.Service Request (See page 23 for information on this feature.) This display occurs

(or Cd)	if the “D” key is pressed to request service. Also displayed if key
	pair [✱] & [#] are pressed and programmed to send a “request for
	service” message. See CALLING FOR SERVICE below.

Total Power Failure If there is no keypad display at all (screen is blank), and all indicators are off, all operating power for the system (from AC and back-up battery) has stopped, and the system is inoperative. CALL FOR SERVICE IMMEDIATELY.

CALLING FOR SERVICE

The “D” key (if present on the keypad, and pressed for 2 seconds), will always send a “request for service” message to the central monitoring station. If key “D” is not present, key pair [✱] & [#] may have been programmed for this message (see page 23), and can then be pressed simultaneously if you wish to request service.

ADDITIONAL SERVICE INFORMATION MAY BE FOUND ON PAGE 43.

– 28 –