Fisher 1225-X manual Pinpointing, Zero Motion Pinpoint Mode

PINPOINTING

ZERO MOTION PINPOINT MODE

The pinpoint mode requires no tuning, no motion, detects all metals and in normal soil it’s even more sensitive than the search mode. Precise target location is a snap.

1.Once the presence of a buried target is identified by the “beep beep” of the 1225-X, simply place the coil lightly on the ground away from the target area. Push the PINPOINT button and hold. (At maximum sensitivity you may hear a faint tone which will disappear as soon as the coil is raised.)

2.Raise the coil one-half inch or so and move

it from side to side across the target area a few times.

3.Stop the search coil over the spot you receive the loudest response.

4.Now move the coil slowly forward and back a couple of times, again stopping over the strongest response.

5.Move the coil side to side one more time and stop over the strongest signal once again. Your target should be in the center of the search coil.

6.For quick and accurate pinpointing of strong signals, place the coil on the ground very close to the target and push and hold the PINPOINT button. You have now “tuned-out” most of the target signal so that when you raise the coil for pinpointing you will only receive a response directly over or very nearly over the target.

9