BATTERY REPLACEMENT
Two nine volt transistor batteries are located in separate compartments at the rear of the housing. When it’s time to replace batteries, always replace both of them.
1.To open, press gently down and out on the battery door latch. The doors are hinged, do not attempt to completely remove them.
2.Tilt the housing gently and the batteries will slide out.
3.Insert the new batteries. Make sure the contact end goes in first and that you match the polarity markings on the control housing.
4.To close, hook the lower edge of the battery door over the inside of the battery compartment and gently push.
5.Some battery brands may be slightly larger than the original batteries, which will cause them to not easily be removed.
Battery Replacement is simple; just pop the doors open,
slide the old batteries out and the new ones in.
Figure 8. Battery Replacement
16
