CONDENSED OPERATING INSTRUCTIONS
We recommend that you first read this entire operating manual before taking your new 1270 out for a test drive. You’ll be more successful, and have a better chance of finding more treasure. But, we also understand the excitement of the “hunt”, so here are some simple instructions for setting up the 1270.
Set the controls as follows:
NORMAL DISC = 5 (iron & foil discrimination) SILENCER switch = ON
IRON DISC switch = OFF
ALL METAL GROUND ADJ. = 0, OFF (completely counter clockwise)
SENSITIVITY = 8
Turn the 1270 ON with the ON /OFF Volume control. (adjust volume to a comfortable level)
Take your 1270 outside. There’s normally too much metal inside to per- form a proper test. Hold the 1270 as shown in Figure 1, and slowly sweep the search coil left and right while moving forward slightly with each sweep. A slight motion is required for the 1270 to detect a target.
It is often helpful to bury a few known targets in the soil to get a “feel” for how the 1270 responds to different targets at various sweep rates. Re- member, at a DISC setting of 5, certain targets such as iron or aluminum should be ignored.
When the 1270 “beeps”, you’ve passed over a metal target with the search coil. Swing the 1270 left and right, then forward and back, making an “X” over the “beep” area. The target will be directly below the center of the search coil. Because the 1270 is a “motion” detector, with practice, this may be the only mode of pinpointing you will need.
To use the
Read this instruction manual thoroughly, practice often and you are in for some exciting treasure hunting. Drop us a line if you have any questions, comments or good finds to tell us about. In the meantime...
HAPPY HUNTING!
2 |