Fisher & Paykel ADN20x36 installation instructions Dcs By Fisher & Paykel Access Doors Adn

DCS BY FISHER & PAYKEL ACCESS DOORS ADN

installation instructions

ACCESS DOOR SPECIFICATIONS:

47-15/16”

35-15/16”

21-7/8”

MODEL: ADN20x48

MODEL: ADN20x36

30”

21-7/8”

MODEL: ADN20x30

24” 1-1/4”

MODEL: ADN20x24

	5/16”
	15/16”
	2-1/8”
	Anchor hole
4-1/4”	(Ø 1/4”)

2”

SIDE VIEW

CUTOUT SPECIFICATION

Vent*	Vent*
	A	B	Vent*
	90º

ACCESS DOOR	A	B
MODELS	(-0”, +1/8”)	(-0”, +1/8”)
ADN20x48	46"	20”
ADN20x36	34"	20”
ADN20x30	28"	20”
ADN20x24	22"	20”

NOTE: The cutout of each corner should be 90° angle in order for the access doors to fit properly. * Island installation to use minimum of 3 vents providing 10 sq. in. per vent (typical).

INSTALLATION INSTRUCTIONS

1.Slide frame into opening (see cutout dimensions in chart above).

2.Check for proper alignment.

3.Using the four slotted holes in the frame as a guide, pre drill four pilot holes on the left & right sides of your island. Secure the unit using screws and anchors suited for the type of cabinet material.

4.Install the access door and check for proper alignment of doors and frame.