![Using your cooktop](/images/new-backgrounds/67780/6778011x1.webp)
4
Using your cooktop
Lighting the cooktop
1Choose the control knob for the burner you want to use.
2 Press the knob down gently and turn it anticlockwise to the High position. The electrodes on all the burners will spark.
Flame failure models only: Hold down the knob for approximately five seconds after the burner has lit. Releasing the knob too soon will extinguish the flame.
3 Adjust the flame anywhere between the High and Low positions. Do not adjust the flame between High and Off O.
Note:
If the burner does not light within 15 seconds, turn the control knob off and wait at least one minute before trying again.
If the cooktop does not light
High
Low
High
Low
If the cooktop does not light, check that:
The cooktop is plugged in and the electricity is switched on.
The gas is turned on.
The electrodes are sparking.
If the electrodes are not sparking, they may be dirty or wet. Clean them with a toothbrush and methylated spirits, as shown in Fig. 6.
Flame failure probe (some models only)
Electrode
Fig.6 How to clean an electrode