Fisher LNS-W03 manual Focus Adjustment, Fig-7

7

MOUNT THE LENS COVER. (See figure-7)

1.Replace Lower Lens Cover. Slide Light-Block Sheet into the guide of Lower Lens Cover and set them in front of the flap. (See Fig. 7.) Fix Lower Lens Cover with 4 Screws C. (See Fig. 2.)

2.Replace Upper Lens Cover. Slide Light-Block Sheet into the guide of Upper Lens Cover and set them in front of the flap. (See Fig. 7.) Fix Upper Lens Cover with 2 Screws A. (See Fig. 1.)

Slide upper both side of LIGHT BLOCK

Sheet into between 1 and 2 .

1CABINET

	Slide into front		Fig-7
FLAP	of the flap.
		UPPER LENS
		COVER

2GUIDE

LIGHT-BLOCK

SHEET

LOWER LENS	FLAP	Slide into front
COVER		of the flap.

FOCUS ADJUSTMENT

Set up the projector and project image on the screen.

1.Loosen the Focus Lock Screw on the projection lens.

2.Rotate the projection lens to obtain proper focus on center area of the screen.

When the distance of the screen and lens is 1 meter, set ● mark (yellow) of the lens on Focus Lock Screw position.

3. Lock the Focus Lock Screw securely.

When proper focus is not observed at outer area of the screen, proceed following adjustments.

4.Loosen the Focus Lock Ring on the projection lens. (Turn the Lock Ring to counter-clockwise.)

5.Rotate the lens to obtain proper focus on outer area of the screen.

6.Lock the Focus Lock Ring securely. (Turn the Lock Ring to clockwise.)

If proper focus is not observed entire screen, repeat above adjustment 1~ 6.

-6-

●mark (yellow)

Focus Lock Ring

Focus Lock Screw