Fisher LNS-W03 manual Adjust Focus, Fig-4, Fig-5, Fig-6

3

INSTALL THE LENS. (See figure-4)

1.Remove protective caps(front and back) on the lens.

2.Mount the lens on mounting bracket of the main cabinet with 4 screws.

Use the screws included with the lens. Use the driver included with the lens to fasten the screws.

(After using, keep it for latter use.)

ATTACHED DRIVER

4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)

Install the light-block sheet around the lens as shown in the illustration. Use the sheet included with the lens.

Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly.

ADJUST FOCUS

Adjust focus following Focus Adjustment on page 6.

LENS MOUNTING BRACKET

Fig-4

LIGHT-BLOCK SHEET

Type FE1

(Part No. 610 280 2634)

Fig-5

5 MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower	UPPER LENS COVER
lens covers, install the light-block sheet so		A
that it should be placed in the guide slot.
(place of the cover plate had been placed.
See figure-2.) If the installation of light-block
sheet is incorrect, it will be the cause of
leakage of light or the dust entering at the
main cabinet.
1. Insert the upper part lens cover and fix
them with screws A (4 screws).
2. Insert the lower part lens cover and fix	A
them with screws B. (2 screws).
	B	Fig-6
	LOWER LENS COVER

-3-