APPENDIX
LAMP REPLACEMENT
When the life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a projected image becomes dark or the color of an image becomes unnatural, replacement of Projection Lamp is required.
Follow these steps to replace the lamp assembly.
1 | Turn off the projector and disconnect AC plug. Allow the |
| projector to cool for at least 45 minutes. |
2
3
Remove a screw with a screwdriver to remove Lamp Cover.
Remove 2 screws with a screwdriver and pull out Lamp Assembly by grasping Handle.
4 | Replace Lamp Assembly with a new one and tighten 2 screws |
| back. Make sure that Lamp Assembly is set properly. Replace |
Lamp Cover and tighten a screw.
5
6
Connect AC Power Cord to the projector and turn it on.
Reset Lamp Replace Counter (refer to the section “Lamp Replace Counter” below).
38