APPENDIX

Problem:

Try these Solutions:

 

 

Picture is L/R Reversed.

Check Ceiling/Rear feature.

 

(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).

 

 

Picture is T/B inverted.

Check Ceiling feature.

 

(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).

 

 

Some displays are not seen

Check Display feature.

during the operation.

(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).

 

 

No sound.

● Check audio cable connection from audio input source.

● Adjust audio source.

 

 

● Press the VOLUME (+) button.

 

● Press the MUTE button.

 

 

Remote control unit does not

● Check the batteries.

work.

● Make sure nothing is blocking between the remote control sensor and

 

remote control unit.

 

● Make sure you are not too far from the projector when using the remote

 

control unit. Maximum operate range 16.4 ' (5 m).

 

● Check the ALL-OFF switch on the Remote Control Unit is set to "ON".

 

● Check the transmitted signal mode from the remote control unit.

 

(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).

 

 

Wireless mouse function

● Check the cable connection between the projector and the computer.

● Check the mouse setting on your computer.

does not work.

 

● Turn on the projector before you turn on the computer.

 

 

SERVICE

WARNING: High voltages are used to operate this projector. Do not attempt to open the cabinet.

You can often correct operating problems yourself. If the projector fails to work properly, see "TROUBLESHOOTING" section on pages 51-52. To correct the failure, try the "Solutions".

Sanyo Services is easily obtained. If after following all operating instructions, you find that service is necessary, contact the SFS Corporation in Los Angeles, or the store where you purchased the unit.

Give the model number and explain the difficulty. We will advise you how to obtain service.

52