CONNECTING PROJECTOR
TERMINALS OF PROJECTOR
This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on pages 11 to 13 and connect properly.
AUDIO INPUT JACKS | |
Connect the | Connect the audio output |
output from video | from video equipment to |
equipment to this | these jacks. |
jack. (Refer to P13.) | (Refer to P13.) |
| ●When the audio output |
| is monaural, connect it |
| to L (MONO) jack. |
COMPUTER IN 1 |
| VIDEO | Pb / Cb – Pr / Cr |
DVI - I | R – AUDIO IN – L (MONO) Y – | ||
| S – VIDEO | AUDIO IN | R – AUDIO OUT – L |
|
| COMPUTER |
|
Connect the composite video output from video equipment to VIDEO/Y jack or connect the component video outputs to VIDEO/Y, Pb/Cb and Pr/Cr jacks. (Refer to P13.)
RESET
Connect an external audio amplifier to these jacks.
(Refer to P12, 13.)
RESET BUTTONThis projector uses a micro processor to control this unit, and occasionally, this micro processor may malfunction and need to be reset. This can be done by pressing RESET button with a pen, which will shut down and restart the unit. Do not use RESET function excessively.
COMPUTER IN 2 / | MONITOR OUT | USB | CONTROL PORT |
|
|
When controlling the computer with Remote Control of this projector, connect the mouse port of your personal computer to this connector. (Refer to P12.)
This terminal is switchable and can be used as computer input or monitor output. Set the terminal up as either Computer input or Monitor output properly before using this terminal. (Refer to P12, 36.)
Note:This terminal outputs analog signal from
COMPUTER IN 1
COMPUTER INPUT (DIGITAL/ANALOG)
Connect computer output (Digital / Analog
Connect the audio output (stereo) from computer to this jack. (Refer to P12.)
When controlling the computer with Remote Control of this projector, connect USB port of your personal computer to this connector. (Refer to P12.)
11