Assembly |
| Parts |
| Assembly |
|
|
|
| |
2nd Panel | Tab |
| 3 | Cap |
1 |
|
| ||
|
|
|
|
Cover
Slots
Grooves
Tabs
| Ribs |
1st Panel | Base |
•Place the base on the surface in which you intend to use the sandbox.
Note: Assemble the panels to the base going in a clock- wise direction.
• | Fit the grooves on one of the panels to the ribs on the |
|
| base, as shown. |
|
• | Fit another panel onto the base. Snap both tabs on the | Cap |
| first panel into the slots on the second panel. | |
|
|
Base
•Insert and snap the cap to the base and panels.
Assembly is now complete.
2 | Let’s Play |
| Push Down |
Tabs | Base |
|
Push Up
Helpful Hint: You may have difficulty snapping the panel tab closest to the base. Lift the assembly up slightly. While pushing up from the underside of the assembly (directly below the tab), push down on the topside of the assembly (directly above the tab).
• Insert and snap the tab on the outside edge of the first
panel into the slot in the outside edge of the second8 Panels panel.
•Repeat this procedure to assemble the remaining six
panels to the base. | • Fill the sandbox with up to 500 lbs. of sand. |
