Assembly
4 | Handle | 5 |
| Assembly |
|
Control
Tower
Handle
Starting
Ramp
Pegs
Tab
Starting
RemoteRamp
Controller
Holder
•"Snap" the remote controller holder onto the tab on the bottom of the starting ramp, as shown.
•Insert and "snap" the pegs on the bottom of the handle assembly into the matching holes in the starting ramp as shown.
•Insert the handle and starting ramp into the matching holes in the control tower as shown.
•Lift the control tower storage compartment door. Insert two screws through the control tower and into the handle. Tighten the screws with a Phillips screwdriver. Do not
•Insert two screws through the holes near the bottom of the control tower and into the pegs in the starting ramp. Tighten the screws with a Phillips screwdriver. Do not
7
