Calibrating the Stylus
Mark on Screen
Tip of
Stylus
Calibration
Hole
IMPORTANT!
From time to time, the mark made on your screen from the stylus and the location of the tip of the stylus may not align. When this happens, you must calibrate the stylus.
•Turn Pixter® over and locate the calibration hole.
•Insert, push and hold the stylus in the calibration hole. Turn Pixter over so that you can see the screen. When you see two , you can remove the stylus from the calibration hole.
•First touch the upper left corner with the tip of the stylus.
•Then, touch the lower right corner with the tip of the stylus.
Hint: After calibrating your screen, the contrast resets to the
To change the contrast on the screen, touch the Save It! tool.
15