Assembly
Retainers
Seat Back Tube
Base Wire
Base Wire
3
• Insert an M5 x 20 mm screw through each foot and tighten.
Flex Base Wires Inward | Pull Up |
Tabs
4
•While flexing the base wires toward each other, hook the footrest onto the ends of the base wires.
•Push the footrest down completely to the tabs on the base wires.
5
• Position the seat back tube above the base assembly.
• Fit the seat back tube completely onto the
base wires.
• Fit a retainer (rounded side inward) to one
end of the seat back tube.
•Insert a #8 x 1,9 cm screw through the outside hole in the seat back tube and into the retainer.
•While holding the retainer in place, tighten the screw.
•Repeat this procedure to secure the other side of the seat back tube to the base assembly using the remaining retainer and #8 x 1,9 cm screw.
•Pull up on the seat back tube to be sure it is secure. If you can remove either end of the seat back tube, you have not assembled it correctly. Remove the screws and retainers.
5
