Setup and Use
WARNING
To prevent serious injury or death:
•Fall Hazard – It is dangerous to use this reclined cradle on an elevated surface, since child’s movement may cause product to slide or tip over. Use only on a floor.
•Suffocation Hazard – Never use on a soft surface (bed, sofa, cushion), since product can tip over and cause suffocation in soft surfaces.
•Always use the restraint system.
•Never leave child unattended.
•Never use as a car seat.
•Never use as a carrier or lift while child is seated. Never use the toy bar as a handle.
•Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg/ 20 lbs).
Restraint Pad 
TIGHTEN
Free End | Buckle |
Anchored End
LOOSEN
Buckle
Free End
2 | Anchored End |
To tighten the belts:
•Feed the anchored end of the belt up through the buckle to form a loop A .
•Pull the free end of the belt B .
•Repeat this procedure to tighten the other belt.
To loosen the belts:
•Feed the free end of the belt up through the buckle to form a loop A . Enlarge the loop by pulling on the end of the loop toward the buckle.
•Pull the anchored end of the belt to shorten the free end of the belt B .
•Repeat this procedure to loosen the other belt.
Note: After adjusting the belts to fit your child, make sure you pull on them to be sure they are securely fastened.
1 | Buckle | Restraint Belt |
|
Securing your Child
•If the toy bar is attached, remove it before placing your child in the seat. Place your child in the seat. Position the restraint pad between your child’s legs.
•Fasten both restraint belts to the buckles on each side
of the restraint pad. Make sure you hear a “click” on both sides.
•Check to be sure the restraint is securely attached by pulling it away from your child.The restraint should remain attached.
•Attach the toy bar, if desired (see Assembly step 7).
3
Calming Vibrations
•Make sure your child is properly secured in the seat.
•To turn vibrations on, slide the power switch on the soothing unit to the on position 
.
•To turn vibrations off, slide the power switch on the soothing unit to the off position 
.
IMPORTANT! If vibrations become faint, or if there are no vibrations, remove the “D” (LR20) batteries from the soothing
unit and dispose of them properly. Replace the batteries with four, new “D” (LR20) alkaline batteries.
7
