Assembly
Frame Leg
Frame Decorated Side
Frame Back Legs
Base
Screw Retainers
7
•Pull the frame leg out on each frame to open. Make sure it "clicks" into place.
•Position a frame so that the decorated side is outward.
•Fit the end of a base into the back leg of a frame.
•Fit a screw retainer over the hole in the back leg, as shown.
•Insert a #10 x 2,2 cm black screw through the screw retainer and back leg. Tighten the screw.
•Repeat this procedure to fasten the other frame back leg to the other side of the base.
Hint: The #10 x 2,2 cm black screws may have been assembled to the screw retainers.
Seat Height Adjusters
Position 4
Press Lever
8
•While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown.
Seat Assembly
Sockets
9 | Seat Bottom Tubes |
|
•Fit the seat assembly between the frames.
•Insert the seat bottom tubes into the sockets in each seat height adjuster.
Hints:
•Be sure the seat height adjusters are in the same position (position 4).
•You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets.
6
