![](/images/new-backgrounds/1134135/13413511x1.webp)
ASSEMBLY
Rounded
Side
14
12
•Fit the ends of the tubes together.
•Fit a lock nut, rounded side out, into the hex hole on the inside of the tube assembly.
•Insert a screw through the hole in the outside of the tube assembly.
•While holding the lock nut in place, tighten the screw.
Rounded
Side
•Insert the inflation pin into the ball.
•Attach the pump (not included) to the pin.
•Inflate the ball to a circumference of 15 1/2" (39 cm), until firm. Do not
•After inflating the ball, remove the pin. Store the pin out of the reach of children for future use.
Assembly is now complete.
Sleeves on
13 | Side Tubes |
|
•Push the net sleeves down on the side tubes.
•Fit two lock nuts, rounded side out, into the hex hole in the inside of each side tube assembly.
•Insert a screw into the outside hole in each side tube assembly.
•While holding the lock nut in place, tighten the screw. Repeat this procedure to fasten the other screw.
6