
PARTS NAMES
Rear Panel
|
| 1 | 4 2 | 576 |
1 | 4 | 56 |
|
|
|
|
| ||
|
|
|
|
1 | 4 2 | 56 |
1 AC input socket (AC INPUT) | 5 | |
Connect the AC power cord (supplied) securely to this | Turn to adjust picture brightness. | |
socket and to a wall outlet. | 6 Vertical Size control | |
2 Video input terminals (VIDEO IN) | ||
Turn to adjust picture vertical size of the picture. | ||
These terminals are used to input a video signal | 7 Vertical hold control | |
source to this monitor. | ||
If the picture is scrolling up or down on the screen, | ||
Connect to the video output of a VCR or another | ||
turn this control until there is a single steady picture. | ||
monitor (for loop through connection) or to a video | ||
| ||
camera. |
| |
3 Video output terminals (VIDEO OUT) |
| |
These terminals are used to output a video signal |
| |
from this monitor. |
| |
| ||
then connect to the video input of another monitor or |
| |
a VCR. |
| |
4 Termination Switch (HI/75Ω (Lo)) |
| |
Select the input impedance (HI/75Ω). |
| |
When using only one monitor, turn the termination |
| |
switch to the 75Ω position. When using more than |
| |
one monitor, set all of the termination switch on the |
| |
monitors to the HI position. However, the last monitor |
| |
termination switch should be in the 75Ω position for |
| |
proper line termination. |
|