Fisher VM-6609, VM-6612, VM-6614, VM-6619 CONNECTION, Note:, Note:, Single Connection, Multiple Connection

CONNECTION

Before connecting your system, make sure that all units are turned off.

The picture signal source can be connected to either the A or B terminal at the rear of the monitor. The monitor selector switch at the front of the monitor can be used to select the input terminal used.

Single Connection

	To Video B
	INPUT terminal
	(Video signal cable)
Monitor	To Video A	Monitor
	INPUT terminal	Monitor
	(Video signal cable)	To Video input
	(Video signal cable)	terminal
Video recorder		To Video input
		To Video input
		terminal
		Video recorder

Video camera

(Rear panel)

Note: The components and connection cables are not included and must be purchased separately.

Multiple Connection

Multi-connection is possible using the loop-through feature of this unit.

When this monitor is connected to additional monitors, the same picture can be obtained on all the connected monitors. Set the final monitor to 75 Ω termination state.

Coaxial cable

To Video input terminal



Monitor	Video recorder	Video camera

Note:

•Do not leave a unused cable and do not connect BNC connector to the last jack of the monitor. Only once connection.

•The components and connection cables are not included and must be purchased separately.