INSTALL THE HOOD
1.Rest the back cavity of the hood on the wood mounting strip.
CAUTION: Hold the hood until it is completely 
! 
secured to the wood mounting strip.
Secure hood to wood strip with (4) screws #8 - 3/4” (for 30” and 36” width hoods) or (6) screws (for 48” and 60’’ width hood) provided at location shown. Drill (2) 3/16” size holes into the drywall for wall anchors through the existing holes in the inside hood back in the locations shown. Then install the (2) wall anchors and attach the hood to these anchors with the remaining #8 - 3/4” screws and the (2) washers provided.
HD0064
2.Attach transition (if required) to blower
Use duct tape to make all joints secure and
NOTE |
Model FBK600 blower plate connects directly to 7” round duct without a transition.
The exterior blower model 332H utilizes a model 332KR mounting plate which connects directly to 10” round ductwork without a transition.
Top of hood (inside view)
Mounting screw locations
Back of hood (inside view)
Wall anchor locations
Warranty
Safety
Operation
HD0049
3.Run power cable to installation location. Refer to the instructions included with the selected blower /
For ducting through back of hood, remove existing plate from inside back of hood and attach to inside top of hood to cover hole. Secure to threaded studs with same (4) nuts.
For ducting through top of hood, existing plate remains in place on inside back of hood.
Connect ducting to transition or
installing the |
|
joints secure and | HD0063 |
9
Plate on top of hood Locknuts
hood
Locknuts
Wiring
cover
Cleaning
Installation
Service Parts
