Flowtron Outdoor Products PV-440 owner manual Maintenance, Axel Fan and Funnel, See Illustration

Models: PV-440

1 4
Download 4 pages 54.45 Kb
Page 3
Image 3
4. Axel Fan and Funnel:

5. Install MA-1000 Octenol Attractant Cartridge:

U.S. Government and university researchers have demon- strated that octenol, a component of human respiration, is an attractant to mosquitoes and biting flies.

The Galaxie PowerVac uses a specially designed time release cartridge containing octenol (1-OCTEN-3-OL). Install the Octenol Cartridge as follows:

a . Release the hood latch by pulling top of latch forward.

b . Raise the hood up to a vertical position.

c.Pull bulb out of its socket.

d.Insert replacement bulb.

e.Close hood and secure with latch

f.Connect power cord and return switch to the “on” position. Use only Flowtron BF-200 replacement bulbs available

from your dealer or from www.flowtron.com.

4. Axel Fan and Funnel:

Clean the axel fan and funnel each time the octenol car- tridge is replaced or more often during periods of heavy

c . Remove the octenol cartridge from its package and peel off the adhesive label covering the evaporation holes.

d.Place the cartridge in the rec- tangle well in the center of the plenum with the evaporation holes facing upward.

See Illustration 4.

e.Close hood and secure the hood latch.

Cleaning

illustration 4

Brush

 

 

Octenol

Plenum

insect infestation.

CAUTION

Always disconnect the power cord from its electrical s o u rce before serv i c i n g , handling or cleaning the unit.

To clean the Fan and Funnel, open the hood latch and lift the hood to an upright position.

a. Clean fan blades and area between the fan blades and the surrounding fan housing using the cleaning brush provided. The brush is located behind the Octenol well.

6 . Position and screw power pack to either an outside or inside wall adjacent to a 115/120 volt A.C. outlet (screws not provided). Run the low voltage wire either above or below ground from the power pack to the unit. Plug the low voltage wire into the power cord connector located at

Simply slide the brush out from its stored location. When complete place cleaning brush back in its proper storage location.

See illustration 4.

b. To clean the funnel, remove the collection tray and then

the bottom of the PowerVac. Plug the power pack into the electrical outlet.

7 . Place the switch located at the rear on the underside of the unit adjacent to the power cord to the “on”position.

Note: Hood must be down and latched to ensure that the built-in interlock is engaged and will allow power to come on.

When the power is applied, the ultraviolet blacklight-blue bulb will emit a bluish glow, the axial fan will rotate, the four colored LED’s will light and oscillate and the built-in heater will heat the entry louver to body temperature.

Maintenance

1.Collection Tray:

Empty the collection tray periodically to ensure proper air flow through the trap. To remove the collection tray, push in on the latch at the front of the tray and pull tray down.

2.Octenol Cartridge:

Replace the octenol cartridge after approximately three weeks of Galaxie PowerVac usage.

3.Ultraviolet Blacklight-Blue Bulb:

To replace the blacklight-blue bulb:

NOTEUltraviolet or “ bl a ck l i g h t ” is invisible to the eye, and its ability to attract insects diminishes ov e r t i m e. T h e r e fore, although the bulb appears to be functioning it should be replaced ev e ry season to maintain optimal “ bl a ck l i g h t ” e f fe c t i v e n e s s .

Push rear of bottom funnel ring up into the unit’s housing until front tabs become disengaged from housing. See figure A .

Pull funnel down and forward releasing rear section of upper funnel surface and remove funnel from unit. See figure B .

Remove insect debris from screen surrounding funnel. Wash screen with water and shake off excess water before re - installing .

Re-install funnel by holding funnel at a slight angle and inserting the front edge of the upper funnel surface inside of unit’s housing. See figure C.

Push funnel upwards and with the rear section of the bottom funnel ring at a slight angle compress funnel until front tabs of bottom funnel ring are up inside of the housing.

See figure D.

Figure A

 

Housing

Up

Bottom

Front

Tab

Funnel

 

Ring

Push Up Here

Figure B

 

 

Down

Upper

Forward

 

Funnel

Tabs

Surface

 

Figure C

 

Front

Up

Edge

 

of Upper

 

Funnel Surface

 

Figure D

 

 

Up

a.Place on/off switch to the ”off” position and disconnect power cord.

b.Open hood latch and raise hood to an upright position.

Close hood, secure with latch, connect power cord and return the on/off switch to the “on” position.

Page 3
Image 3
Flowtron Outdoor Products PV-440 Maintenance, Axel Fan and Funnel, See Illustration, Collection Tray, Octenol Cartridge