![](/images/new-backgrounds/1135404/13540473x1.webp)
Operation 5
Mid Range Piston Assembly
8.Install the weight adapter (P/N
•Add the Mass of the adapter to the tare for the Piston
•Add the height of the adapter to the L1 dimension for the Cylinder (approximately .21 inches)
The gauge is now ready for operation.
Mid Range Piston Assembly
Refer to Figures
If the Mid Range Piston Assembly is to be used:
1.The Lower Thrust Bearing
2.Next, insert the Lower Cylinder Spacer,
3.Place the Cylinder Retainer
4.Place the Cylinder Retaining Cap
5.Tighten this cap securely by hand while holding the column with the opposite hand.
6.Before proceeding, check the level vial to verify that the base is level, adjust the level of the base if necessary.
7.Install the weight adapter (P/N
•Add the Mass of the adapter to the tare for the Piston
•Add the height of the adapter to the L1 dimension for the Cylinder (approximately .21 inches)
The gauge is now ready for operation.