Press “SET” to continue.
SSave new setting
8.6.4 Program Function Mode
The nextparameter is the program function or cycle mode. There are four pos-
sible modes which determine whether the program will scan up (from set-point
1 to n) only or both up and down(from set-point n to 1), and also whether the
program willstop after one cycle or repeat the cycle indefinitely. The table be-
lowshows the action of each of the four program mode settings.
Function Action
1up-stop
2 up-down-stop
3 up-repeat
4 up-down-repeat
Pf=1 Program mode
Use the“UP” or “DOWN”buttons to change the mode.
Pf=4 New mode
Press “SET” to continue.
SSave new setting
8.6.5 Program Control
The finalparameter in the program menu is the control parameter. You may
choose between three optionsto either start the program from the beginning,
continuethe program from where it was when it was stopped, or stop the
program.
Pr=OFF Program presently off
Use the“UP” or “DOWN”buttons to change the status.
Pr=StArt Start cycle from beginning
Press “SET”to activate the new program control command and return to the
temperature display.
9105/9107 33
8Controller Operation