6.Do not wear clothing with attachments, i.e. toggles or drawstrings that can be drawn into the air inlet.
7.Inspect your product before each use. Replace any worn or damaged parts.
8.Do not use if any part is damaged or broken or if any of the screws are loose. Have it repaired by an authorised repairer.
9.Always check your product is in a safe operating condition before use.
Use
1.Use the product only in daylight or good artificial light.
2.Do not use the product when it is raining or in damp and wet areas.
3.Never use the product in or near water or ponds.
4.Know how to stop the product quickly in an emergency.
5.On slopes, be extra careful of your footing and wear
6.Never pick up or carry the product by the cable.
7.Keep children, pets and bystanders at a safe distance when using your product.
8.Keep long hair away from air inlet.
9.Keep all inlets clear of debris.
10.Always remain alert.
11.Do not attempt to use your product for vacuuming without the fully assembled debris bag fitted.
12.Never blow debris in the direction of bystanders.
13.Do not overreach. Keep proper footing and balance at all times.
14.Remove the plug from the mains :
-before removing or replacing fully assembled debris bag;
-before leaving the product unattended for any period;
-before clearing a blockage;
-before checking or cleaning the appliance;
-if the product starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury.
Maintenance and storage
1.Keep all nuts, bolts and screws tight to be sure the product is in a safe working condition.
2.Replace worn or damaged parts for safety.
3.After use the product should be stored in a safe place where it is protected from damage.
4.Inspect the collection bag regularly. If the collection bag becomes worn or damaged, replace.
Cables
IMPORTANT
Use only 1.00mm2 size cable up to 30 metres length maximum.
Maximum rating :
1.00mm2 size cable, 10 amps 250 volts AC.
1.Mains cables and extensions are available from your local Husqvarna Outdoor Products Approved Service Centre.
2.Only use extension cables specifically designed for outdoor use.
Assembly Instructions
WARNING: Stop the unit and disconnect the mains electricity supply before opening the inlet cover or attempting to insert or remove the inlet restrictor, blower tube, or vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades.
WARNING: If received assembled, ensure your unit is properly assembled and all fasteners are secure.
