Flymo 2000 instruction manual Starting and Stopping, Operation, Maintenance, Before each use

Models: 2000

1 68
Download 68 pages 39.28 Kb
Page 6
Image 6

Starting and Stopping

WARNING: You MUST make sure the tubes

are secure before using the unit. WARNING: Do not use the unit without the

tubes or collection bag properly attached to avoid flying debris and/or impeller contact which can cause serious injury. Always wear eye protection to prevent rocks or debris from being blown or ricocheting into the eyes and face which can result in blindness or serious injury.

Operation

Operating position

Eye Protection

Eye Protection

BlowerVacuum

Using your unit as a blower

WARNING: Inspect the area before using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation.

Use your unit as a blower for:

Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.

Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or between bricks.

Direct air flow by directing the blower tube down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences.

Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face. Be careful when working near plants. The force of the air could damage tender plants.

Using your unit as a vacuum

WARNING: Do not vacuum stones, gravel, metal, broken glass, etc., to avoid severe damage to the impeller. To avoid the possibility of electrical shock, do not attempt to vacuum water or other liquids.

Use your unit as a vacuum to pick up dry material such as leaves, grass, small twigs, and bits of paper.

Move slowly back and forth over the material as you vacuum. Avoid forcing the unit into a pile of debris as this can clog the unit.

Keep the vacuum tube about an inch above the ground for best results.

WARNING: If the unit becomes clogged, stop the unit and disconnect the mains electricity supply. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris.

Maintenance

WARNING: Stop the unit and disconnect the mains electricity supply before performing maintenance.

General recommendations

The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this

manual. Various adjustments will need to be made periodically to properly maintain your unit.

Before each use

Check for loose fasteners and parts

Inlet Cover

Blower Tube

Vacuum Tubes

Collection Bag

Page 6
Image 6
Flymo 2000 instruction manual Starting and Stopping, Operation, Maintenance, Before each use