Flymo 2700XV manual How to Use

How to Use

J1

K

J2
L	+	-

Cable Restraint

1.Form loop in mains cable and push the loop through the slot (J1).

2.To secure, position loop over the hook and pull the cable back through the slot (J2).

WARNING

The use of eye protection is recommended. The use of ear protection is recommended. To prevent dust irri- tation, the wearing of a face-mask is recommended. Never point your product at bystanders.

Using As A Blower

Blow Mode - The product will blow debris from pa- tios, paths, driveways, lawns, bushes, borders etc.

M

N

1.Point nozzle towards the ground.

2.To start squeeze the switch lever (K).

3.Stand back from debris to be cleared.

4.To control the speed of the blow mode, use the variable speed dial. Move the dial forward for a faster speed and backwards for a slower speed (L).

5.Point the tube towards the debris and slowly approach (M).

6.To stop release the switch lever.

• If Blow performance is reduced, the blow outlet may be blocked. Switch off the product and dis- connect from the mains electricity supply. Re- move the Blow Tube and clear any blockage in the blow outlet using a blunt implement (N)

Using As A Vacuum

Vacuum Mode - In this position your product will pick up leaves, small twigs and garden debris.

•For best performance, turn speed control to maximum.

1.Position the tube slightly above the debris, squeeze the switch lever (E) and move the product slowly back and forth (P).

3.Do not force the tube into the debris as this will impair performance.

4.To stop release the switch lever.

•If Vacuum performance is reduced, the Debis bag inlet may be blocked. Switch off the prod- uct and disconnect from the mains electricity supply. Remove the Debris Bag and clear any blockage in the Debris Bag inlet using a blunt implement (Q)

P

Q