Flymo 350, 330 manual Cables

current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.

2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.

3.Do not use the lawnmower if the electric cables are damaged or worn

4.Immediately disconnect from the mains electricity sup- ply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or dam- aged cable. Replace it with a new one.

5.Your extension cable must be unwound, wound cables can overheat and reduce the efficiency of your mower.

6.Keep cable away from lawnmower, always work away from the power point mowing up and down, never in circles.

7.Do not pull cable around sharp objects.

8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.

9.Switch off, remove plug from mains and examine electric

supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable.

10.Always wind cable carefully, avoiding kinking.

11. Never carry the product by the cable.

12.Never pull on the cable to disconnect any of the plugs. 13.Use only on AC mains supply voltage shown on the

product rating label.

14.Our products are double insulated to EN60335. Under no circumstance should an earth be con- nected to any part of the product.

Preparation

1.While using your product, always wear substantial footwear and long trousers.

2.Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade.

3.Before using the machine and after any impact, check for signs of wear or damage and repair as necessary.

4.Replace worn or damaged blades together with their fixings in sets to preserve balance.

Use

1.Use the lawnmower only in daylight or good artificial light.

2.Avoid operating your lawnmower in wet grass, where feasible.

3.Take care in wet grass, you may lose your footing.

4.On slopes, be extra careful of your footing and wear non-slip footwear.

5.Mow across the face of slopes, never up and down.

6.Exercise extreme caution when changing direction on slopes. Walk never run.

7.Mowing on banks and slopes can be dangerous. Do not mow on banks or steep slopes.

8.Do not walk backwards when mowing, you could trip.

9.Never cut grass by pulling the mower towards you. 10.Switch off before pushing the mower over surfaces

other than grass.

11.Never operate the lawnmower with damaged guards or without guards in place.

12.Keep hands and feet away from the cutting means at all times and especially when switching on the motor.

13.Do not tilt lawnmower when the motor is running, ex- cept when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before return- ing the appliance to the ground.

14.Never pick up or carry a mower when it is operating or still connected to the mains supply.

15.Remove the plug from the mains :

- before leaving the mower unattended for any period; - before clearing a blockage;

- before checking, cleaning or working on the appliance; - if you hit an object. Do not use your lawnmower

until you are sure that the entire lawnmower is in a safe operating condition;

- if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury.

Maintenance and storage

1.Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition.

2.Check the grassbox/grassbag frequently for wear or deterioration.

3.Replace worn or damaged parts for safety.

4.Only use the replacement blade, blade bolt, spacer and impeller specified for this product.

5.Be careful during adjustment of the lawnmower to prevent entrapment of the fingers between moving blades and fixed parts of the machine.

6.Store in a cool dry place and out of reach of chil- dren. Do not store outdoors.

Cables

CABLES		MAINS PLUG REPLACEMENT
IMPORTANT		IMPORTANT
•	Use only 1.00mm2 size cable up to 40 metres length	•	If the plug supplied is cut off it should be de-
	maximum.		stroyed. There is an electric shock hazard if a cut
Maximum rating : 1.00mm2 size cable, 10 amps 250 volts AC.			off plug is inserted into a 13 amp socket.
•	THE VISION COMPACT IS SUPPLIED WITH AN	1.	No earth required. Flymo products are double insu-
	ELECTRIC MAINS CABLE FITTED WITH A FE-		lated to EN60335 and under no circumstances
	MALE CONNECTOR		should an earth be connected to any part of the
1.	Flymo Mains Cables and Extension Cables are		product.
	available from your local Approved Service Centre.	2.	Ensure the mains voltage suits your product
2.	Do not wire an extension cable directly to your product	3.	IMPORTANT!
	yourself. Please contact your local Approved Service		The wires in the mains lead are coloured in accor-
	Centre for further information on the connectors and		dance with the following code:
	kits available.		BLUE	-	NEUTRAL
3.	Only use extension cables specifically designed for		BROWN	-	LIVE
	outdoor use.		The wire which is coloured BLUE must be con-
CONNECTORS			nected to the Terminal which is marked with the let-
IMPORTANT			ter 'N' or coloured BLACK.
•	Flymo connectors are suitable for use with 2 core		The wire which is coloured BROWN must be con-
	cable only. Under no circumstances should these		nected to the Terminal which is marked with the let-
	connectors be used for earthed products.		ter 'L' or coloured RED.
•	All Flymo connectors and cables are of splashproof con-	4.	It is important that the outer sheath is clamped cor-
	struction. They are not waterproof and must not be left		rectly into the 3-pin plug.
	outside permanently nor should they be submerged or im-	5.	If in doubt consult your local Service Repairer or
	mersed in water. Do not let cable lay or trail through pools		qualified electrician before the machine is used.
	of water or splashed with water from hose pipes.	6.	A 13 Amp fuse must be fitted to the Mains Plug.
		7.	The normal plug fuse and household fuse only pro-
			tect the electrical equipment and are not a safe-
			guard against electrocution.