N
1
Using the Shrubbing position
1.By pressing the lever (N1) with your foot, the handle can be lowered into three different positions to enable the use of the product under shrubs and low obstacles (P).
P
Manual line feed
To manually feed the nylon line (Q) | Q | ||
1. | If required line can be fed out manually. | ||
| |||
2. | To operate, press and release manual line feed button, |
| |
| whilst gently pulling on one of the lines until the line |
| |
| reaches the line cutter. |
| |
3. | When the required amount of line is fed out, gently pull |
| |
| on the second line (there is no need to press the man- |
| |
| ual line feed button again). |
| |
4. | If the line extends past the line cutter, too much line |
| |
| has been fed out. |
| |
5. | If too much line is fed out, remove the spool cap and click |
| |
| spool |
| |
•Always return the product to its normal operating po- sition before switching on.
manual line feed button
Cutting Head
To remove spool cap
1.Press and hold in the two cap release latches. (R).
2.Pull cap away from the spoolholder. (R).
When refitting the spool cap
1.Keep all areas of the cap and spoolholder clean. Failure to do so may prevent the cap being securely located in the spoolholder.
2.Replace the cap, pressing firmly DOWN towards the spoolholder to ensure cap is fully located.
3.Check that the cap is correctly fitted by trying to re-
move it without depressing the two latches.
To replace nylon line.
For your convenience it is recommended you buy spool and line complete. Nylon line only is also available. Both are available from Husqvarna UK Ltd. stockists.
To fit spool and line complete:
1.Remove the cap.
2.Remove old spool.
3.Place spool into spoolholder.
4.Release one line from cleat (T1).
5.Secure line into slot (S1).
6.Repeat for second line.
•Ensure spool is fully located by gently rotating it during fitment, whilst keeping the spoolholder steady.
7. Refit the cap.
To fit nylon line only:
•Remember! Your Flymo Trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line.
1.IMPORTANT - Always wind the line onto the upper section of the spool first.
Take approximately 5 metres of line. Insert 15mm of line into one of the holes in the upper section of the spool (T) and wind line in the direction of the arrows on the top of the spool. Leave approximately 100mm of line unwound and place into cleat as illustrated in figure T1. Repeat on lower section of spool.
2.Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the ef- ficiency of the automatic line feed.
3.Then fit spool as described in ‘To fit spool and line complete’, section above.
•Always return the product to its normal operating po- sition before switching on.
R |
| Cap |
|
| |
|
| Cap release |
Spool |
| latch |
|
| |
Spoolholder |
|
|
|
| Slot |
S |
| S1 |
| T1 | Cleat |
|
| |
T |
|
|
