6
Spool cap and nylon line cont’
To replace nylon line.
For your convenience it is recommended you buy spool and line complete. Nylon line only is also available. Both are available from Electrolux Outdoor Products stockists.
•If you have spool and line complete, follow steps 5 to 11.
•If you have nylon line only, follow the full procedure below.
•IMPORTANT
Always wind the line onto the upper section of the spool first.
•Remember! Your Flymo Trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line.
1.Take approximately 5 metres of line. Insert 15mm of line into one of the holes in the upper section of the spool (Q) and wind line in the direction of the arrows on the top of the spool.
2.Leave approximately 100mm of line unwound and
place into cleat as illustrated in figure | R. |
3.Repeat on lower section of spool.
4.Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the efficiency of the automatic line feed.
5.Remove the cap.
6.Remove the old spool.
7.Place spool into spoolholder.
8.Release one line from cleat.
9. Secure line into slot | (P). |
10.Repeat for second line. |
|
•Ensure spool is fully located by gently rotating it dur- ing fitment, whilst keeping the spoolholder steady.
11. Refit the cap.
Q
upper section
| lower section |
R | SECURING LINE INTO CLEATS |
|
Maintenance
•WARNING
Disconnect from the mains electricity supply, before attempting any maintenance or adjustment.
Cutting head continues to rotate after the trimmer has been switched off. Keep fingers and hands clear of the line cutter on leading edge of guard.
Caring for your
After you have finished using your Flymo
Revolution follow the procedure below:
1.Disconnect from the mains electricity supply.
2.Never clean your trimmer with water, cleaning fluids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
4. Using a soft brush, clean around the inside of the
safety guard, the cutting head | (Fig S) and the motor | |
housing air vents. | (Fig T) |
|
5.Inspect the trimmer carefully, especially the parts of the cutting head.
6.If your trimmer is damaged in any way contact your local
Electrolux Outdoor Products approved service centre.
•Never use a damaged trimmer.
7. Wind cable carefully to avoid kinking.
8. Store in a cool, dry place and out of reach of children.
S |
T |
Environmental Information
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the prod- ucts’ life.
•Packaging is recyclable and plastic components have been labelled (where practical) for cate- gorised recycling.
•Awareness of the environment must be considered when disposing of
•If necessary, contact your local authority for disposal information.
