Assembly Instructions, Starting and Stopping, Lock-off, Button

Assembly Instructions

Assembly of lower handle to hood (A)

1.Place the ends of the lower handle into the slots

2.Secure lower handle to hood by firmly pushing fix- ing pin through holes in hood and handle (A1).

3.Repeat on the other side.

•NOTE

Should a problem occur when securing handle with the fixing pin, carefully lever the pin out of location and repeat steps 1 to 3 above.

Fitting Upper Handles to Lower Handles (B)

1.Ensure the upper handle is located correctly with the lock-off button on the switchbox uppermost.

2.Ensure the upper handle and the lower handle are aligned correctly.

3.Insert the nut into the handle knob.

4.Fit the bolts, washers and handle knobs.

5.Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles.

Cable clips (C)

1.Fit the cable to the handles with the clips provided.

2.Ensure the the cable is secured under the clip on the hood.

		Starting and Stopping
D	E	Starting
		1.	Form loop in mains cable and push the loop through
			the slot as illustrated in picture (D).
		2.	To secure, position loop over the hook and pull the
			cable back through the slot as illustrated in picture (E).
		3.	Connect plug to mains.
		4.	To prevent a ring being cut in your lawn and to clear
			any residual grass in the collection chute, tilt your
			lawnmower slightly (F).
		•	The switchbox is provided with a lock-off button
			(G1) to prevent accidental starting.
		5.	Press and hold the lock-off button (G) on the switch-
	F		box, then squeeze one of the Start/Stop levers
	F		towards the upper handle (H).
		6.	Continue to squeeze the start/stop lever towards the
			upper handle and release the lock-off button.
		7.	When the product has reached full speed gently
			lower it onto the lawn.
		•	NOTE There are two start/stop levers fitted.
			Either one can be used for starting the product.
		•	IMPORTANT Do not use the start/stop levers
			intermittently
		Stopping
		1.	To prevent a ring being cut in your lawn, tilt your
			product slightly (F).
		2.	Release the pressure on the Start/Stop lever.
G		H
	1