Adjusting the Cutting Height
J 
HIGHEST 
This symbol visible
K | LOWEST |
| This symbol visible |
L |
| 1 |
| 2 | 3 |
|
| |
M |
|
|
|
| 1 |
|
| 3 |
| 2 |
|
•THERE ARE 2 CUTTING HEIGHTS (J & K)
•Height of cut is adjusted by turning over the cutting head.
•Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down.
•To Remove the Cutting Head and Fan (L)
Hold the fan firmly and twist the cutting head anti- clockwise as illustrated. Hold the cutting head in the centre and remove as illustrated. Hold fan in the centre and remove as illustrated.
•Inspect for damage and clean as necessary before replacing the fan and the cutting head.
•To Refit the Fan and the Cutting Head (M)
Replace the fan as illustrated. Replace the cutting head, adjusting the height of cut as required. Hold the fan firmly and twist the cutting head clockwise, as illustrated.
•IMPORTANT
ENSURE FAN AND CUTTING HEAD ARE COR- RECTLY LOCATED
How to Use
N |
1.Start at the edge of the lawn nearest to the power
point so the cable is laid out on the lawn you have already cut. (N)
2.Cut your grass twice a week during the growing season, your lawn will suffer if more than a third of
its length is cut at one time.
Do Not Overload Your Product
Using in long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your product which may cause damage. When using in long thick grass a first cut with the cutting height set higher will help reduce the load. See Adjusting the Cutting Height.
