Flymo Minimo manual Starting and Stopping, Adjusting the Cutting Height, How to Use, Lowest

Starting and Stopping

D

Lock-off button

Switch lever

Starting

1.Hold as illustrated in Fig D.

2.To start, press the lock-off button down, whilst pressing the lock-off button, squeeze the switch lever.

Stopping

1. To stop your product, release the switch lever.

Adjusting the Cutting Height

E HIGHEST

This symbol visible

• THERE ARE 2 CUTTING HEIGHTS (E & F)

• Height of cut is adjusted by turning over the cutting head.

F	LOWEST
	This symbol visible

G	1
	3
	2
H
	1
	3
	2

•Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down.

•To Remove the Cutting Head and Fan (G)

Hold the fan firmly and twist the cutting head anti-clockwise as illustrated. Hold the cutting head in the centre and remove as illustrated Hold fan in the centre and remove as illustrated

•Inspect for damage and clean as necessary before replacing the fan and the cutting head

•To Refit the Fan and the Cutting Head (H)

Replace the fan as illustrated. Replace the cut- ting head, adjusting the height of cut as required. Hold the fan firmly and twist the cut- ting head clockwise, as illustrated.

•IMPORTANT

ENSURE FAN AND CUTTING HEAD ARE CORRECTLY LOCATED

How to Use

1.Start cutting the edge of the lawn nearest to the power point so that the cable is laid out on the lawn you have already cut.

2.Cut twice a week in the growing season, your lawn will suffer if more than one third of its length is cut at one time.

Do not Overload your Product

Cutting long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your product which may cause damage. When using in long thick grass, a first cut with the cutting height set higher will help reduce the load. See Adjusting the Cutting Height.