SPRODUCT DESCRIPTION Fig, ASAFETY MARKINGS, BASSEMBLY

SPRODUCT DESCRIPTION (Fig. 0)

1.	Supply cord retainer	9.	Adjustable shaft
2.	Rear handle	10.	Shaft locking button
3.	Assist handle lock buttons	11.	Assist handle
4.	Air vents	12.	On/Off trigger
5.	Debris shield	13.	Mains cable

6.Cutting line head

7.Edging guide / line protector

8.Motor housing

aSAFETY MARKINGS

The following symbols on your trimmer are intended to remind you of some of the most important safety precautions:

1.WARNING. This product is potentially dangerous. Take great care at all times to avoid injury.

2.Read the operator’s manual.

3.Disconnect the mains plug if the cord is damaged.

4.Wear eye protection at all times.

5.Approved ear defender.

6.Do not work near bystanders.

7.Do not use in rain or damp conditions.

8.LWA indicates the noise power level. Wear ear plugs or mufflers if necessary.

9. indicates that the product conforms to the relevant European Directives as required by law.

bASSEMBLY

DEBRIS SHIELD INSTALLATION

Fig. 2-1

1.Position the motor housing with string head carrier facing up.

2.Slide debris shield over motor housing as shown.

Fig. 2-2

3.Align edging guide with mating grooves and push firmly in the direction shown until an audible

snap is heard.

NOTE: Be certain that edging guide is oriented as shown. Once edging guide, motor housing and debris shield are mated the connection is permanent and cannot be removed without a special tool.

EXCHANGE OF SPOOL

Turn off the machine and disconnect the plug from power supply. Wait until nylonline has come to a complete stop. Pict. 2-3 Press both press-buttons 1 and lift off the cover 2. Pict. 2-4 Replace the empty spool 3 by inserting each line end through the eyelets as shown. Secure the spool with a slight turn to ensure correct position in the base plate. Then replace the cover ensuring both press-buttons lock in. NOTE: The complete spool and line must be replaced and line must be replaced and is available as an accessory.

cPRODUCT ADJUSTMENTS

Fig. 3-1 - Adjustment Assist Handle

1.Using thumb and forefinger push in both spring loaded lock buttons at the base of the assist handle in order to release the ratchet adjustment mechanism.

2.Adjust handle as necessary and release automatic lock buttons.

Fig. 3-2 - Adjust Shaft Length

1.Grip shaft firmly.

2.Push red shaft release button forward and move handle forward or backward to desired length. NOTE: Shaft may be adjusted in trimming or edging mode.

Fig. 3-3 - Edging Conversion