5.18'' Models Only: To assemble nex flex line, insert flex tube into end of compression nut with small opening. Place sleeve over end of flex tube and into compression nut. Repeat for other end. Attach new flexible gas line to valve and burner routed through grate as shown in Figure 3. It is very important that you route the flex line through the back leg on the grate. It could interfere with placement in fireplace if routed around leg.
WARNING: Test all gas piping and connections, internal and external to unit, for leaks after installing or servicing. Correct all leaks at once.
Compression Nut 
Sleeve
Valve
WARNING: Never use an open flame to check for a leak. Apply a noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks
Burner
See your owner's manual for complete instructions on checking your gas connections.
Compression | Sleeve |
Nut |
Figure 3 - Routing and Installing Flexible Gas Line for 18'' Models
(Log Set Not Shown For Clarity)
2701 S. Harbor Blvd. |
| |
Santa Ana, CA 92704 | ||
REV. B | ||
www.fmiproducts.com | 02/11 |
2