
INSTALLATION
Continued
WARNING: Do not allow any combustible/noncombustible materials to overlap the firebox front facing.
WARNING: Do not allow combustible or noncombustible materialstocoveranynecessary openings like louvered slots.
WARNING: Never modify or cover the louvered slots on the front of the firebox.
Mantel Clearances for
Installation
If placing mantel above
NOTICE:Ifyourinstallationdoes not meet the minimum clearances shown, you must do one of the following:
•raise the mantel to an accept- able height
•remove the mantel
Removing Upper Louver
To install mantel or blower accessory, you must first remove the upper louver.
1.Lift screen off fireplace and remove log set if installed.
2.Remove 4 screws from upper louver (see Figure 12). Save these screws.
3.Pull upper louver straight out from the cabinet. Be careful not to scratch the paint. Set louver aside.
4.Open lower louver door by swinging door down (see Figure 12).
NOTICE: Surface temperatures ofadjacentwallsandmantelsbecome hotduringoperation.Walls and mantels above the firebox may become hot to the touch. If installed properly, these temperatures meet the requirement of the national product standard. Follow all minimum clearances shown in this manual.
| 10" |
|
| Mantel Shelf | |
Note: |
|
|
|
| |
8" |
|
|
|
| |
All vertical |
|
|
|
| |
measurements | 6" |
|
|
|
|
|
|
|
| ||
are from top of |
|
|
|
| |
2 1/2" |
|
|
|
| |
fireplace |
|
|
|
| |
opening to |
|
|
|
|
|
bottom of |
|
|
|
|
|
mantel shelf. All |
|
|
|
|
|
measurements |
|
|
|
|
|
are in inches. |
|
|
|
|
|
| 15" | 18" | 21" | 23" |
|
|
|
|
|
|
|
Side of Firebox
Figure 11 - Minimum Mantel Clearances
for
Top
Louver
Bottom Louver
Figure 12 - Removing Top Louver and
Opening Bottom Louver
OPTIONAL MANTEL Installation
Refer to instructions provided with the mantel for assembly instructions.
Installing Optional Blower Accessory GA3450TA
Refer to instructions provided with the blower for assembly instructions.
12 | www.fmiproducts.com |