CLEANING AND MAINTENANCE

Continued

We also recommend that you keep the burner tube and pilot assembly clean and free of dust and dirt. To clean these parts we recommend using compressed air no greater than 30 PSI. Your local computer store, hardware store or home center may carry compressed air in a can. If using compressed air in a can, please follow the directions on the can. If you don’t follow directions on the can, you could damage the pilot assembly.

1.Shut off unit including pilot. Allow unit to cool for at least 30 minutes.

2.Inspect burner, pilot and primary air inlet holes on orifice holder for dust and dirt

(see Figure 33).

3.Blow air through the ports/slots and holes in the burner.

4.Check the orifice holder located at the end of the burner tube again. Remove any large particles of dust, dirt, lint or pet hair with a soft cloth or vacuum cleaner nozzle.

5.Blow air into the primary air holes on the orifice holder.

6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air

Orifice Holder

Burner

Tube

Primary Air

Inlet Holes

Figure 33 - Orifice Holder On Outlet

Burner Tube

inlet hole about 2" from where the pilot flame comes out of the pilot assembly (see Figures 34 or 35 depending on model). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.

Pilot Air Inlet Hole

Pilot Assembly

Figure 34 - Pilot Inlet Air Hole

(Propane/LP Gas)

Pilot Air Inlet Hole

Pilot Assembly

Figure 35 - Pilot Inlet Air Hole

(Natural Gas)

LOG Set

If you remove one-piece log set for clean- ing, refer to page 16, for placement instruc- tions.

Replace log set if broken or chipped (dime- sized or larger).

CABINET

Air Passageways

Use a vacuum cleaner or pressurized air to clean.

Exterior

Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.

Wiring Diagram

(Remote-Ready

 

 

 

Blue

 

 

 

 

 

 

 

 

Models Only)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TPTH

 

TH

 

 

 

 

Gas Control

 

 

 

Red

TPTH

TP

 

 

Thermopile

 

 

 

 

 

 

 

White

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

124979-01C

www.fmiproducts.com

21