Hood Assembly
WARNING: Always have screen in place before operating fireplace. This prevents excessive temperatures on fireplace surfaces.
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.
6.Insert screws as shown in Figure 4. Tighten screws firmly.
Shoulder Screw
Screen
Tools Required: |
|
| |
• | Phillips screwdriver | • | slotted screwdriver |
• | 5/16" hex wrench | • | scissors |
1.If equipped, lift fireplace screen up and pull out to remove (see Figure 3). Set screen aside until installation has been completed.
2.Cut two plastic straps to remove log from firebox cavity. Set log aside.
3.An optional blower is available. See Ac- cessories, page 31. Install optional blower now. Follow installation instructions pro- vided with blower.
4.Locate four black Phillips sheet metal screws in hardware packet.
5.Slide hood between louver and firebox top and align screw holes.
Figure 3 - Removing and Installing Screen
Louver | Firebox Top |
| |
Sheet Metal |
|
Screws |
|
Hood
Figure 4 - Assembling Hood
Air for Combustion and Ventilation
WARNING: This heater shall notbeinstalledinaroomorspace unless the required volume of indoorcombustionairisprovided by the method described in the National Fuel Gas Code, ANSI Z223.1/NFPA54, the International Fuel Gas Code, or applicable local codes. Read the following instructionstoinsureproperfresh air for this and other
Today’s homes are built more energy efficient than ever. New materials, increased insulation and new construction methods help reduce heat loss in homes. Home owners weather
strip and caulk around windows and doors to keep the cold air out and the warm air in. During heating months, home owners want their homes as airtight as possible.
While it is good to make your home energy efficient, your home needs to breathe. Fresh air must enter your home. All
Exhaust fans, fireplaces, clothes dryers and fuel burning appliances draw air from the house to operate. You must provide adequate fresh air for these appliances. This will insure proper venting of vented
PROVIDING ADEQUATE VENTILATION
The following are excerpts from National Fuel Gas Code, ANSI Z223.1/NFPA 54, Air for Combustion and Ventilation.
6 | www.fmiproducts.com |