www.fmiproducts.com 119315-01D22
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON po-
sition. Slid e the remote se lector switch
to the REMOTE position (see Figure 29).
Note: The burner may light if hand-held
remote was on when the remote selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
opERaTiNG FiREplaCE
Continued
Figure 29 - Setting the Selector Switch
and Control Knob for Hand-Held Remote
Operation
Control
Knob
Selector Switch in
REMOTE Position
(Optional Hand-Held
Remote Control)
Electronic
Ignitor
GWMT1 WALL MOUNTED
THERMOSTAT (OPTIONAL)
Make sure the heater switch is on REMOTE
and set the temperature adjustment on
wall thermostat to the desired setting.
The thermostat has been electronically
calibrated at the factory and requires no
adjustment or leveling.
Upon installation, the thermostat must be
allowed to stabilize at room temperature
for a minimum of 30 minutes for proper
operation. See installation instructions on
page 17 of this manual.
GWMS2 WALL MOUNTED
SWITCH (OPTIONAL)
Make sure the heater switch is on RE-
MOTE. This wall switch works just like the
conventional light switch. Flip the switch
up for on and down for off.
Note: Make sure that this switch is not in a
position to be mistaken for a light switch.
This may result in the replace being in-
advertently turned on without the proper
precautions being taken. See installation
instructions on page 18 of this manual.
NOTICE: You must light the pilot before using the hand-held re-mote control unit. See Lighting Instructions on page 20.