![](/images/new-backgrounds/1027655/276555x1.webp)
OWNER’S MANUAL
SAFETY
INFORMATION
Continued
12.This heater needs fresh, outside air ven- tilation to run properly. This heater has an oxygen depletion sensor (ODS) pi- lot light safety system. The ODS shuts down the heater if not enough fresh air is available. See Air for Combustion and Ventilation, pages 4 through 6. If heater keeps shutting off, see Trouble- shooting, pages 17 through 19.
13.Do not run heater
•where flammable liquids or vapors are used or stored
•under dusty conditions
14.Do not use this heater to cook food or burn paper or other objects.
15.Do not use heater if any part has been exposed to or under water. Immediately call a qualified service technician to in- spect the room heater and to replace any part of the control system and any gas control which has been under water.
16.Do not operate heater if any log is bro- ken. Do not operate heater if a log is chipped
17.Turn heater off and let cool before ser- vicing. Only a qualified service person should service and repair heater.
18.Operating heater above elevations of 4,500 feet could cause pilot outage.
19.Provide adequate clearances around air openings.
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic, dancing yellow flames. This heater is designed for
SAFETY PILOT
PRODUCT IDENTIFICATION
Log Set
Burner
Piezo Ignitor
Base Assembly
Control Knob
Figure 1 - Heat Majic™ Log Set
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
UNPACKING
CAUTION: Do not remove the data plates from the grate assem- bly. The data plates contain impor- tant product information.
1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by the burner. This could damage heater. Always handle base assembly by grate.
2.Remove all protective packaging ap- plied to logs and heater for shipment.
3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.
105192 | 3 |