OPERATING INSTRUCTIONS
SLIDER / DAMPER SET-UP
THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION.
A Qualified Service Technician or Installer must set the Slider Damper. This is used to regulate the airflow through the pellet stove. The slider damper knob is located on the left cab side (see Figure 7).
Figure 8: Efficient Flame.
SPECIAL NOTES:
Pellet quality is a major factor in how the Pellet stove will operate. If the pellets have a high moisture or ash content the fire will be less efficient and has a higher possibility of the fire building up and creating clinkers (hard ash
Figure 7: Slider / Damper Knob.
If the fire should happen to go out and the heat output indicator has been set on the lowest setting, the Slider Damper should be pushed in slightly, decreasing the air in the firebox.
If, after long periods of burning, the fi re builds up and overfl ows the burn pot or there is a build up of clinkers, this would be a sign that the pellet quality is poor, this requires more primary air, the slider damper must be pulled out to compensate. Pulling the slider damper out gives the fi re more air.
The easiest way to make sure that an efficient fl ame is achieved is to understand the characteristics of the fi re.
•A tall, lazy fl ame with dark orange tips requires more air – Open slider (pull out) slightly.
•A short, brisk fl ame, like a blowtorch, has too much air – Close slider (push in) slightly.
•If the fl ame is in the middle of these two characteristics with a bright yellow/orange, active fl ame with no black tips then the air is set for proper operation, refer to Figure 8.
The combustion exhaust blower is a variable speed blower controlled by the heat output button. This blower will decrease the vacuum pressure inside the stove and as the heat output button is turned down.
NOTE:
Incorrect use of the Damper will cause malfunction and poor results from your stove or insert.
OPERATION
Greenfi re Pellet Stove and Insert Owner's Manual | 9 |
