INSTALLATION
Continued
bracket (see Figure 14). Secure speed control to bracket with lock nut by pushing and turning lock nut with pliers clockwise until it is tight against bracket.
7.Remove knockout plug from louver panel by pressing top and bottom retaining clips (see Figure 11, page 13).
8.Place louver panel, louvers pointing up, back into framed opening.Align control shaft with rectangular opening by sliding control bracket along flange (see Figure 14).
9.Fully seat louver panel into frame open- ing by gently pressing along ends until all dimpled retainers have snapped in place.
10.Place control knob, provided, onto control shaft (see Figure 14).
11.Check to make sure power cord is com- pletely clear of blower wheel and there are no foreign objects in blower wheel. Also, double check all wire leads and make sure wire routing is not pinched or in a precarious position. Correct accordingly.
CAUTION:Nevertouchblower wheel while in operation.
12.Turn on power to duplex outlet if previ- ously turned off per warning in column 1, page 14.
13.Plug in blower power cord to duplex outlet
(see Figure 12, page 14).
Firebox Face
Hearth | Screw | |
Head and | ||
Pan | ||
Top Hole | ||
Flange | ||
on Bracket | ||
| ||
Speed |
| |
Control |
| |
Bracket |
|
Lower
Flange
Control |
|
Knob |
|
Lock Nut | Control |
Lower | Shaft |
| |
Louver |
|
Figure 14 - Attaching Speed Control to
Firebox with Panel Louvers
14.Turn blower on and check for operation. Turn blower off by turning knob fully coun- terclockwise before continuing.
15.Peel off backing paper and stick supplied wiring diagram decal on firebox bottom approximately 12" in from of blower (see
Figure 15).
16.Replace all panels and/or brick bottom panel if previously removed.
Variable | Fan Switch | |
Fan Switch | ||
|
| (N.O.) |
Off 1 | 2 Black |
|
| On | Blue |
|
| |
|
| Red |
110/115 |
| (BKT Model |
| Only) | |
V.A.C. Black |
| |
|
| |
Green |
| Blower |
White |
| Motor |
Wiring Diagram
Decal 12" in
Front of Blower
Figure 15 - Location of Wiring Diagram Decal (Model May Vary From Illustration)
Model BK3 Installation
1.Remove knockout plug from louver panel by pressing top and bottom retaining clips (see Figure 11, page 13).
2.Place BK3 fan assembly between two leg stands with fan blades pointing toward rear of fireplace (see Figure 16).
Screws
BK3 Blower | Leg | |
Stands | ||
|
Figure 16 - Mounting BK3 Blower
www.fmiproducts.com | 15 |