INSTALLATION
Continued
COMBUSTION AIR KIT MODEL AK4 (OPTIONAL)
The outside air kit may be installed on the left side of the fireplace only. The vent can be installed through any outside wall a minimum of three feet below fireplace termination cap. The handle to operate the damper door for the outside air inlet will be located inside the left “screen pocket” of the firebox (see Figure 20). Pull the handle to open or push to close.
CAUTION: Air inlet ducts are not to terminate in attic space.
Screen Pocket
Air Kit
Handle
Figure 20 - Air Kit Handle Location
INSTALLING FIREPLACE HOOD AND SCREEN
1.Attach hood to firebox using screws pro- vided (see Figure 21).
2.Insert each rod through all rings located at top of screen.
3.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using #10 x 3/8" Phillips screw provided (see Figure 22).
4.Insert other rod into front hole on right side of firebox and fasten using remaining Phillips screw.
Hood
Screws 
Figure 21 - Screw and Hood Placement
(Model May Vary From Illustration)
Top View of Rod Layout
Rear Hole
FrontIdentification
Hole | Label Location |
Rod
Ring
Screen
Screw
Figure 22 - Installing Fireplace Screen (Model May Vary From Illustration)
www.fmiproducts.com | 17 |