www.fmiproducts.com 125078-01B20
FirePLAce inStALLAtiOn
Continued

LAVA ROCK, DECORATIVE GRATE,

EMBER FLAKES AND SCRAP LOG

INSTALLATION

Lava rock, ember akes and scrap log pieces are
included with your replace. Install these items
while glass doors are open and/or removed.
1. Follow instructions from Removing/Re-
placing Glass Door, page 19, to move
glass out of the way of this installation.
2. For 36" models only, install 3 loose logs
by placing log #1, log #2 and log #3 onto
one piece log as shown in Figure 25.
3. Place lava rock around base of burner.
Make sure burner ports are not covered
(see Figure 26).
4. Place ember akes around front and sides of
burner and on burner ports (see Figure 27).
This will create the glowing ember appearance
as the ame touches the ember akes. Do not
block burner ports or pilot ports by overlapping
ember akes in one area. It is not necessary
to use all ember material provided.
5. Place scrap log pieces randomly behind
grate as shown in Figure 28 on lava rock
and around (but not on) burner ports.
6. Place grate in front of logs as shown in
Figure 28. Be sure grate is balanced so it
does not fall or lean onto logs. Grate does
not attach to hearth assembly.
Figure 26 - Installing Lava Rock
Figure 27 - Installing Ember Flakes
Figure 28 - Installing Scrap Log Pieces
Lava Rock
Ember Flakes
Scrap Log Pieces

REMOVING LOGSET/BURNER

MODULE

Connecting and Disconnecting Gas Line
WARNING: A qualied ser-vice person must connect and disconnect replace with gas supply. Follow all local codes.
1. Using a 5/16" hex socket wrench or nut-
driver, connect or disconnect exible gas line
and control valve (see Figure 29, page 21).
2. After connecting gas line to control valve,
always test for leaks.
Figure 25 - Installing Loose Logs
Log #2 Log #1
Log #3