Fireplace Installation

Continued

4.Tilt glass assembly fully vertical until outer pivot pin snaps into mounting hole in up- per spring clip (see Figure 31).

5.Once top and bottom pins are secured, unfold door into closed position.

6.Repeat process for opposite door as- sembly.

7.To adjust doors, slide them partially open. Using a screwdriver, loosen hold-down screws in spring clip and pivot plate (see Figure 32).

8.Close both doors until evenly joined at middle and note gap at outer edges of the face.

9.Reopen one door at a time and retighten upper and lower hold-down screws.

10.Repeat process until both doors are even- ly joined, spaced and working freely.

CAUTION: The glass panels become very hot while the appliance is operating. Do not attempt to adjust or clean the glass doors until the appliance has fully cooled.

Insert Pin Into Spring Clip

Spring Clip

Slide Top

Pin Into

Door Track

Insert Bottom Pivot Pin Into

Pivot Plate and Swing Door

Into Vertical Position

Spring

Hold-Down

Clip

Screw

Side

Front

Face

Partially

Opened

Door

Figure 32 - Adjusting Glass Doors

Removing Glass Doors for Replacement or Cleaning

1.Partially open door and press up on upper spring clip with a screw driver until outer top pivot pin is free of clip.

2.Fully fold frame assembly and slide upper edge towards center of firebox opening until guide pins are free of frame rail (see Figure 33).

CAUTION: Always operate the appliance with the doors either fully opened or fully closed. Operating the appliance with the doors partially open can result in improper venting of flue products.

Fold Bi-Fold

Spring Clip

Door After

 

Releasing

 

Spring Clip

 

and Slide

 

Door Out of

Depress

Upper Track

Spring Clip

 

 

to Release

 

Pivot Pin

Pivot Plate

 

 

Figure 31 - Installing Optional Glass

Remove Bottom Pin

 

Door

 

From Pivot Plate While

Pivot Plate

 

 

Sliding Door Out of

 

 

 

Upper Track

 

 

Figure 33 - Removing Glass Doors

108794-01G

www.fmiproducts.com

17