Fortinet 5020 !

FortiGate-5020 Chassis Guide

801-30000-0043-20061207

Turning on FortiGate-5020 chassis power FortiGate-5020 hardware procedures

Once the FortiGate-5020 chassis is connected to two AC power sources you can

turn on the power by switching on the circuit breakers at the back of the

FortiGate-5020 chassis (see Figure 2 on page 6 for location of the circuit

breakers).

The FortiGate-5020 chassis should power up. If the FortiGate-5020 is operating

correctly, from the grille at the panel at the top of the FortiGate-5020 chassis you

should be able to see that the LEDs of both FortiGate-5020/5050 power supplies

are lit. As well the PSU A and PSU B LEDs on the right side of the chassis front

panel should be lit (see Figure 1 on page 5).

In addition, if any FortiGate-5000 series modules have been installed in the

chassis they should power on and their front panel LEDs should indicate that they

are operating normally. If any of these LEDs are not lit, there may be problems

with the FortiGate-5020/5050 power supplies.

You can insert FortiGate-5001SX or FortiGate-5001FA2 modules into the

FortiGate-5020 chassis. Arrange the modules in slots as required for your

configuration. FortiGate-5001SX or FortiGate-5001FA2 modules can be installed

in both of the FortiGate-5020 slots.

Your FortiGate-5020 chassis may have been shipped with temporary slot filler

panels that include a warning message to read the FortiGate-5000 documentation

before installing your product. The temporary slot fillers must be removed and all

slots filled; either with FortiGate-5001SX or FortiGate-5001FA2 modules or with

air baffle slot fillers. Air baffle slot fillers are similar to blank FortiGate-5000

modules and are required for proper cooling air flow.

See the following documents for information about installing and removing the

FortiGate-5001SX or FortiGate-5001FA2 modules:

FortiGate-5001SX:

•FortiGate-5001SX Security System Guide

FortiGate-5001FA2:

•FortiGate-5001FA2 Security System Guide

!Caution: FortiGate-5000 series modules must be protected from static discharge and

physical shock. Only handle or work with FortiGate-5000 series modules at a static-free

workstation. Always wear a grounded electrostatic discharge (ESD) preventive wrist or

ankle strap when handling FortiGate-5000 series modules.

!Caution: Do not operate the FortiGate-5020 chassis with open slots on the front panel. For

optimum cooling performance and safety, the slots must contain a FortiGate-5000 series

module or an air baffle slot filler.