Foster e 7370 230 What to do in Case of a Problem, Symbol E 4 displays, Control panel displays U

WHAT TO DO IN CASE OF A PROBLEM

The symbol [ E 4 ] displays :

∙The hob must be configured according to the following procedure.

I)Warning : before starting all pots must be removed from the cooktop.

II)Disconnect the cooktop from the main supply : remove fuse or disconnect circuit breaker.

III)Connect the cooktop to the main supply : replace the fuse or connect the circuit breaker. IV) Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm minimum diametre.

* start within 2 minutes after the connection to the main supply

*do not use the [ O/I ] key.

V)How to cancel the existing configuration :

1)7331230 : Push on key [ - ] and keep your finger on

the key

7370230 : Push on key [ 1 ] and keep your finger on the key

2) With a finger from the other hand : activate anti-	c	b
clockwise successively and quickly all other existing	d	a
[ + ] keys. Start with the front right cooking zone and
move anti-clockwise (a -> b -> c -> d). A double "beep"
sound will inform you of a bad manipulation and you
will have to restart from point 1.

3)Take your fingers off the touches and re-touch and hold down [ - ] for a few seconds, until blinking [ E ] appears.

4)Wait until [ E ] becomes permanent.

5)The [ E ] will be transformed automatically into [ C ]. The configuration has been done.

Nota : Cooktops with 3 heating zones : Start the procedure with the rear right [ + ] key (b) ( the front right zone doesn't exist...)

VI) How to configure the hob ?

1)Use a suitable induction pot with a minimum diametre size of 16cm.

2)Select the heating zone by pushing the corresponding [ + ] key.

3)Put the pot on the corresponding heating zone.

4)Wait until [ C ] converts to [ - ]. The zone is configured

5)Use the same procedure for each other heating zone which displays [ C ]

6)The configuration is made if all zones are detected and if nothing is displayed Use only 1 pot to configure the hob.

Never put two or more pots on the heating zones during the configuration.

∙If [ E 4 ] display persists call the After-sales Service

The hob or the cooking zone doesn’t start-up :

∙The hob is badly connected on the electrical network.

∙The protection fuse cut-off.

∙The looking function is activated.

∙The sensitive keys are covered of grease or water.

∙An object is put on a key.

The control panel displays [ U ]:

∙There is no pan on the cooking zone.

∙The pan is not compatible with induction.

∙The bottom diameter of the pan is too small.

26