Foundations 100-SSC-R Installation, Recommended Blocking, Operation, USE of Restraint System

INSTALLATION

Recommended Blocking:

Wood double stud blocking is necessary. Contact an architect and building official to make sure the blocking is adequate and complies with building codes (Fig. a.).

1"

(25.4 mm)

355/8"

(905 mm)

3 7/8"

(98.4 mm)

For A. D. A. compliance, top of lower double stud should be 30“ (76 cm) from the floor.

1. Slide changer into blocking area and mark mounting hole location on blocking studs.

HINT:This may require 2 additional people to help hold changer in position while you are marking the locations.

2. Use a power drill with a 3/16” bit and drill six (6) pilot holes in the blocking studs.

3. Shim changer for a snug fit.

For A. D. A. Compliance

	35 5/8" (905 mm)
	Rough-in
	Double Stud
Stud
Double	18"
	(457 mm)
	Double Stud

Double Stud

195/8"

(499 mm) Rough-in

NOTE: If lower holes are inaccessible, remove plastic unit from steel back by removing the 4 Truss Head Spanner Screws (fig. c). Once steel back is attached to blocking, reconnect plastic wall to steel back using the same spanner screws.

4. Align holes in changer with drilled holes and secure using the wood screws. Wood screws have been provided and are for wood only (Fig. b). NOTE: It is installers responsibility to provide correct fastereners

for other substrates.

5. Ensure all six (6) screws are tight.

30”

(76 cm)

A. F. F	Fig. a
	Recess	Recess
	Mounting
	Holes	Mounting
Recess		Holes
Mounting
Holes

OPERATION:

Rotate base downward. Place infant on top of the changing surface. Use restraint system as described below. After child has been changed, remove restraint system and rotate base back up against the wall.

Fig. b

Truss Head

Spanner Screws

USE OF RESTRAINT SYSTEM:

Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock the strap into place. Slide red locking tab over top of buckle (Fig. d). Reverse steps to loosen strap.

MAINTENANCE AND CLEANING:

Check all hardware and components monthly or as required to ensure hardware is tight and there are no missing or damaged components. Take unit out of service if any component is missing or damaged and contact customer service to order replacement parts. Do not substitute parts.

For replacement parts, contact customer service at 1-877-716-2757.

Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong chemical cleaners or cleaning agents that may be hazardous to children.

	Fig. c
Top Of	Locking
Buckle	Tab
	Fig. d

WARNING

•

• Avoid serious injury from falling or sliding out. Always use restraint system.

Child should never be left unattended.

• Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to

exist.2