Fixing the frame
• Loosen the two screws fastening the lower chimney and re- move this from the lower frame.
• Loosen the two screws fastening the upper chimney and re- move this from the upper frame.
If you wish to adjust the height of the frame, proceed as follows: |
|
| |
• | Unfasten the eight metric screws joining the two columns, lo- |
|
|
| cated at the sides of the frame. | 1 | 1 |
• | Adjust the frame to the height required, then replace all the |
|
|
| screws removed as above. |
|
|
• Insert the upper chimneystack from above, and leave it running |
|
| |
| free on the frame. | 2 | 2 |
• | Lift up the frame, fit the frame slots onto the screws up to the |
|
|
| slot end positions. |
|
|
•Tighten the two screws and fasten the other two screws pro- vided with the hood.
Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes.
•The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device.
On completion, check that the base is stable, even if the frame is subjected to bending.
•In all cases where the ceiling is not strong enough at the sus- pension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts.
Note: The Hood body should be secured to ceiling joists. If nec- essary, install a wood support behind the dry wall, flush mounted between 2 joists. This will provide the necessary structure and support for mounting.
EN |
| 1 |
| 10 |
