freeView Power 80 User Manual
Phone Controllabe: Set whether the port can be configured through the telephone port.
Control Type: Set the method the freeView Power 80 uses to turn off the outlet.
•Safe shutdown: Turn off the port after the amount of time specified in the Power Off Delay field.
•Safe reboot: Turn off the port after the amount of time specified in the Power Off Delay field. Then turn the port back on after the amount of time specified in the Power Resume Delay field.
•Instant shutdown: Turn off the port immediately.
Power Off Delay: The amount of time to wait before turning the port off in seconds. Applies only when the Control Type is set to Safe Shutdown or Safe Reboot.
Power Resume Delay: The amount of time to wait before turning the port on in seconds. This is used to prevent a surge in power from all devices turning on at the same time. Applies only when the unit initially powers on and if “All On” is selected in the RPM Status page.
When either Safe Shutdown or Safe Reboot is selected, the freeView Power 80 will send a shutdown signal through the
To activate support of the shutdown command on the computer, the operating system must be running Windows 2000/XP/2003. To enable safe shutdown, perform the following steps:
1.Go to Control Panel Æ Power Options.
2.Select the UPS tab.
3.Choose to add a UPS then click Select.
4.Choose Generic as the manufacturer.
5.Click Custom under model type, and then select the COM port that the unit is connected to.
6.Click Next.
7.On the next screen (Figure 27), make sure all three options are checked, and that the Negative radio button is selected for each option.
8.Click Finish.
Figure 27 – UPS Configuration Screen
25
